Standard flywheel cover....



you can see the gear/clutch of the leccy boot at the top, looks like a seperate casting, but it's all part of the side cover.

Which will be replaced by this....



I'm undecided as to if I'm going to use this brand new conrod, it's a prox one and there's not a lot of play in the rod on the XL600 crank...




Bit's still to find....

I've got a Joy engineering replica of the HRC RS600 flat tracker camshaft, an XR500 high compression wiseco piston, which seized in the bores, I'm pretty sure it only needs new rings and will clean up, but I can't spot it.