GT up date..

**Buddy** · 12-01-2008, 16:07

If you need any machining done Croft engineering in Sawley are very helpful .The boss of the place cold bored and reground my C90 head stock bearings to take a standard derbi stem for £15 .... did a top job

**von41** · 12-01-2008, 16:58

cool thanks bud..

**Archangel** · 13-01-2008, 00:48

You're all gay as get out.

**von41** · 15-01-2008, 17:40

* blows Kiss *

**von41** · 21-01-2008, 18:18

finely!!! am moving on... got Bandit 600 front forks & yokes...

£125..sweet.

after removing GT yokes, and doing some measuring to the yoke stem.. have found that a 15mm thick spacer to the bottom of the Bandit yoke stem, where the bottom taper bearing gos should work well.. then take 3mm off the thickness of the stem, so the GT bottom taper bearing will fit, the top bearing is same size so no need to alter that, but may need a 5mm spacer for the steering lock nut ?.

took the yokes to work today.. had the yoke stem pressed out of the bottom yoke so it can be turned down.. "5 tonne popped it out"..no trouble!!

next step... the arse end.. keeping with bandit, going to graft the bandit swing arm on.. but convert it to twin shock try and keep to the 70's look if i can ?..